MGDX500BW
Maytag MGDX500BW Bravos X Dryer Repair
Most common issues on this model
- Drum spinning with no warm air
- Dryer that shuts down before clothes are dry
- Burnt-lint odor from the vent or door
- Rumble when the drum turns
MGDX500BW is a dryer from the Maytag Bravos X line. Only the BW version is listed, so the number on your door frame should read the same as this page. The MGD prefix normally marks a gas dryer, and that is something we verify on the rating plate when we arrive.
Bravos X dryers usually live in a hall closet, a laundry room or a garage corner, where the vent often runs further than it should. When there is no heat, we look at the igniter, the flame sensor and the gas valve coils. When the dryer quits early, we measure airflow and test the thermal fuse and the thermostats. A lint odor sends us to the blower housing and the exhaust path.
Once the cause is found, you get the cost on paper and decide whether to go ahead. The rating label gives us the number and serial we order against, and the work carries 30 days of workmanship coverage.
Key features
- Maytag Bravos X line
- Clothes dryer
- Listed under the single suffix BW
Error codes this model can show
What would cause a burnt lint smell in my dryer?
Lint caught near the burner, blower or in the vent can heat up and smell. We clear what we can reach, test airflow, and tell you whether the duct needs further work.
The label only shows BW at the end. Is that normal?
Yes. This model is listed with the one BW version, so the full MGDX500BW on your label matches this page. If yours differs, we still match the label before ordering parts.
Why does my dryer tumble without heating?
A gas dryer needs the igniter to glow, the sensor to confirm it, and the valve coils to open. We test these in sequence and check the thermal fuse, then quote the part that failed.
Book repair for your MGDX500BW
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.