Error code · Dryer

Maytag Dryer Code F3E2: Moisture Data Missing for Five Loads

Low risk · DIY check OK

Code: F3E2
Appliance: Dryer
Brand: Maytag
Warranty: 30-day workmanship

What F3E2 means

A Maytag electric or gas dryer with an electronic control shows F3E2 after five loads in a row dry without the moisture sensor registering any data. The sensors are the metal strips inside the drum that the clothes touch. You will see the code on the display, and automatic dry cycles may not end correctly. Pressing POWER clears the message so you can restart. We see this older dryer control often in Houston.

Common causes of F3E2

Dryer not level, so clothes do not touch the moisture sensor strips
Dirty or coated sensor strips inside the drum
Wiring or connector from the sensor to the control
Moisture sensing input on the control

✓ One safe check you can try

1. Press POWER to clear the code and restart the dryer. 2. Check that the dryer sits level on all four feet and does not rock. 3. Wipe the metal sensor strips inside the drum with a damp cloth, then dry them. 4. Run a normal load and see whether the code returns. 5. Keep the lint screen and vent hood clean.

! Why to stop there

If F3E2 returns even with a level dryer and clean strips, the problem is in the sensor wiring or the control input.
We test the sensor circuit directly instead of replacing parts by guesswork.
You see the written price before any work, and the repair carries our 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

F2E2Maytag Dryer Code F2E2: Keypad and Control Power PFMaytag Dryer Code PF: Power Failure in the Middle of a Cycle F2E4Maytag Dryer Code F2E4: User Interface or Wiring F2E5Maytag Dryer Code F2E5: Control Panel Communication F3 E4Maytag Dryer Code F3 E4: Sensor Circuit Needing a Reset F3E1Maytag Dryer Code F3E1: Exhaust Thermistor Out of Range F3E3Maytag Dryer Code F3E3: Inlet Thermistor Reading Low or High F3E5Maytag Dryer Code F3E5: Five Loads in a Row Without Moisture Data

F3E2F3E2 questions

Why does a dryer need a level floor for the moisture sensor?

A dryer that leans can keep clothes from touching the sensor strips. With no contact, the control reads no moisture data and eventually shows F3E2.

Will pressing POWER fix it?

It clears the message and lets you restart. If the sensor still gets no data over later loads, the code comes back and the dryer needs a check.

Can I keep drying until it is fixed?

A timed dry cycle usually works because it does not depend on the sensor, but watch the load and the heat. We can test the sensor circuit when you are ready.

Book a visit

Still unsure about F3E2?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390