Error code · Washer

Maytag Top-Load Washer Code F0E0: Message to Reset the Power

Low risk · DIY check OK

Code: F0E0
Appliance: Washer
Brand: Maytag
Warranty: 30-day workmanship

What F0E0 means

F0E0 appears on Maytag top-load HE washers with an electronic control, from the Bravos, Bravos X and Bravos XL era through current models such as the MVW6230HW, MVW7232HC, MVWC565FW and MVWB765FW. The manufacturer states no cause for this code and gives only one step: reset the power. So the washer is telling you the control stopped the cycle, and it does not say why. The older Bravos models are still in many homes, and we repair them, and we say plainly when a repair is not worth it.

Common causes of F0E0

A one-time control stop that clears with a power reset
A repeat of the code, which makes us check what the washer was doing when it stopped
The control board and its connections, only after the other checks

✓ One safe check you can try

1. Disconnect the power cord from the outlet. 2. Leave the washer unplugged for 5 minutes. 3. Plug it back in and start the cycle again. 4. If F0E0 shows up again, write down what the washer was doing when it stopped and let us look at it.

! Why to stop there

No cause is given for this code, so a repeat tells us nothing until we watch the washer run
We test the control and its wiring for a reason the code does not reveal
If the washer is an older Bravos, we say plainly whether a repair is worth the cost

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Rinse Light OnMaytag Top-Load Washer Rinse Light On: Spray Rinse Is Running SdMaytag Bravos Washer Code Sd: Suds Reduction Routine at the End of the Wash Sensing or Fill LightMaytag Top-Load Washer Sensing or Fill Light: Auto Sensing Is Measuring the Load SrMaytag Neptune Washer Code Sr: System Relay Problem Sud or SdMaytag Washer Code Sud or Sd: Too Many Suds, Extra Rinsing Under Way tEMaytag Neptune Washer Code tE: Sump Thermistor Reading Outside Normal Range uLMaytag Bravos Washer Code uL: Unbalanced Load, Correction Routine Running Wash Light On or FlashingMaytag Top-Load Washer Wash Light On or Flashing: Water Level Not Changing

F0E0F0E0 questions

What does F0E0 mean on a Maytag top-loader?

The manufacturer gives no specific cause for it. The only listed step is to disconnect power for 5 minutes and then restore it, so treat it as a control message rather than a named part.

Will unplugging the washer clear it?

Often it does. Leave it unplugged for 5 minutes, plug it back in and run the cycle. If the code returns the same way, there is something worth diagnosing.

Do you repair older Bravos washers?

Yes. They are still in many homes. We give a written price before work, say plainly if a repair is not worth it, and back our work with a 30-day warranty.

Book a visit

Still unsure about F0E0?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390