Error code · Range

Maytag Range Code F8, Meat Probe Plug Check

F8 is a short code on Maytag electric and gas ranges with a meat probe, such as the MER8850DS. It asks you to make sure the probe is firmly in the probe receptacle, which sits in…

Low risk · DIY check OK

Book a House Call (713) 936-6390

Code: F8
Appliance: Range
Brand: Maytag
Warranty: 30-day workmanship

What F8 means

F8 is a short code on Maytag electric and gas ranges with a meat probe, such as the MER8850DS. It asks you to make sure the probe is firmly in the probe receptacle, which sits in different places depending on the model. The control is reporting that it does not see a proper connection. Owners find the code when they start a probe-assisted cook or when the oven starts, and the cycle may not begin until the code is dealt with.

Common causes of F8

Probe plug seated only part way
Probe wire or plug worn
Receptacle contact or wiring
Probe input on the control

✓ One safe check you can try

1. Make sure the oven is cool, then push the meat probe firmly and fully into its receptacle. 2. Take the probe out if you are cooking without it. 3. Switch the range's breaker off for one minute and back on. 4. Look for the code again after a minute. 5. Verify oven operation with a plain bake.

! Why to stop there

When the code stays with the probe out, the receptacle, wiring or control input is what remains.
We test the receptacle with a known good probe so you are not billed for a part that was working.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

Probe or Insert ProbeMaytag Range Message "Insert Probe": Meat Probe Not Detected PUSH or PSHMaytag Range Prompt PUSH or PSH: Press Start Sabbath, Sab, 5Ab or 5A7Maytag Range Sabbath Mode Display: Cancel Sabbath Mode FBE1, FBE2 or FEE8Maytag Range Codes FBE1, FBE2 and FEE8: Reset and Recheck FC E1, FC E2 or FC E3Maytag Range Codes FC E1, FC E2 or FC E3: Wi-Fi Connection Lost FC E4 or FC E5Maytag Range Codes FC E4 and FC E5: Wi-Fi Antenna Concern FC E6 or FC E9Maytag Range Codes FC E6 and FC E9: Wi-Fi Power Module FC E7Maytag Range Code FC E7: No Link to Home Router

F8F8 questions

Why do I see F8 with no probe in the oven?

The control still checks the probe circuit. A dirty or damaged receptacle, or a wiring or control issue, can look like a missing probe even when you are not using one.

Where do I find the receptacle?

It is inside the oven cavity, often on a side wall near the front. The exact place depends on your model, and your use and care guide shows it.

Is F8 an emergency?

No. It is one of the lower-risk codes, and ordinary baking without the probe is usually fine once the code clears. Call us if it keeps returning.

Book a visit

Still unsure about F8?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390