Error code · Range

Maytag Range Codes 3d31, 3d32 and 3d41: Meat Probe Connection

Low risk · DIY check OK

Code: 3d31, 3d32 or 3d41
Appliance: Range
Brand: Maytag
Warranty: 30-day workmanship

What 3d31, 3d32 or 3d41 means

These three codes appear on Maytag electric and gas ranges with a meat probe feature, such as the MER8850DS. The message is about the meat probe: the control does not see it properly connected to the receptacle inside the oven, and the receptacle location varies by model. The owner sees the code during a probe-based cook or when the oven starts, and the cycle may not begin. A loose plug is the first thing to rule out, since the circuit is otherwise simple.

Common causes of 3d31, 3d32 or 3d41

Probe plug not fully seated in the oven receptacle
Probe cable or tip worn from repeated use
Receptacle or wiring behind it with a poor connection
Oven control reading the probe circuit

✓ One safe check you can try

1. With the oven cool, check that the meat probe is pushed all the way into its receptacle; the location differs by model. 2. Remove the probe if you are not using it for this cook. 3. Turn off the range's breaker for one minute, then switch it back on. 4. Watch the oven for one minute to see if the code returns. 5. Verify oven operation with a normal bake.

! Why to stop there

If the code stays with the probe removed, the receptacle, wiring or control needs testing and a reset cannot settle it.
We try a known good probe and inspect the receptacle, so you do not pay to replace a part that was fine.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

Sabbath, Sab, 5Ab or 5A7Maytag Range Sabbath Mode Display: Cancel Sabbath Mode Probe or Insert ProbeMaytag Range Message "Insert Probe": Meat Probe Not Detected PUSH or PSHMaytag Range Prompt PUSH or PSH: Press Start FC E4 or FC E5Maytag Range Codes FC E4 and FC E5: Wi-Fi Antenna Concern FC E6 or FC E9Maytag Range Codes FC E6 and FC E9: Wi-Fi Power Module FC E7Maytag Range Code FC E7: No Link to Home Router FC E8Maytag Range Code FC E8: App Registration Error Feature Not Available or Fault DetectedMaytag Range Message "Feature Not Available": Cook Cycle Entry Halted

3d31, 3d32 or 3d413d31, 3d32 or 3d41 questions

Do I need the meat probe to use the oven?

No. If you are baking without the probe, take it out of the receptacle so the control stops looking for it. Normal bake and broil should then run without these codes.

Where is the probe receptacle?

It sits inside the oven cavity, usually on a side wall, though the exact spot varies by model. Your use and care guide shows it. Make sure the plug is pushed in fully and sits straight.

Why would the code appear with no probe plugged in?

The control checks that circuit at startup. A damaged receptacle, wiring or the control itself can send a reading that looks like a bad probe. We test each before replacing anything.

Book a visit

Still unsure about 3d31, 3d32 or 3d41?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390