Error code · Range

Maytag Range Code F0 E0: Unrecognized Control Error

Medium · inspection needed

Code: F0 E0
Appliance: Range
Brand: Maytag
Warranty: 30-day workmanship

What F0 E0 means

F0 E0 shows on Maytag electric and gas freestanding and slide-in ranges, such as the MER7662WS0. It is the catch-all code. The electronic oven control cannot recognize what type of problem has happened, so it reports a general condition in the oven control system, the control board or the wiring. Owners see the code and may find the oven will not heat, stops mid-cycle or does not respond to the keypad. Because the code is general, the next step is a reset, then a close look if it returns.

Common causes of F0 E0

Electronic control board reporting an unspecified condition
Wiring or connector in the oven control system
Power disturbance that left the control in an unclear state

✓ One safe check you can try

1. Turn the oven off and let it cool. 2. Switch the range's circuit breaker off for one minute. 3. Switch it back on. 4. Monitor the oven for one minute to confirm the code does not display again. 5. Verify oven operation with a short bake before using it for a meal.

! Why to stop there

Since the control itself cannot name the problem, a repeat of F0 E0 leaves several circuits open.
We narrow it down by testing the control output and the wiring, then give you a written price before we replace anything.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

Probe or Insert ProbeMaytag Range Message "Insert Probe": Meat Probe Not Detected PUSH or PSHMaytag Range Prompt PUSH or PSH: Press Start Sabbath, Sab, 5Ab or 5A7Maytag Range Sabbath Mode Display: Cancel Sabbath Mode Indicator Flashing on a Range CooktopMaytag Range Cooktop Indicator Light Flashing: Stuck Touch Keys Indicator or Hot Light On a RangeMaytag Range Hot Light Staying On: Cooktop Control or Element Still Warm Lo or PreMaytag Range Display Lo or Pre: Oven Warming Up F9-1, F9-2 or F9-3Maytag Range Codes F9-1 Through F9-3: Door Lock Switch Lock on the CooktopMaytag Range Cooktop Lock Message: Touch Controls Disabled

F0 E0F0 E0 questions

Why does F0 E0 not name a part?

The control could not classify what went wrong. That is why we trace the control system step by step instead of assuming a board is bad.

Will the breaker reset fix it?

It often clears a one-time event. If the code returns after the one-minute reset and the one-minute watch, the cause is still present and needs testing.

Is it safe to keep baking?

Wait until the code is gone and a short bake behaves normally. A control that cannot identify its own problem should not run long cycles on its own.

Book a visit

Still seeing F0 E0?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390