When a Maytag washer fills slowly or not at all, the problem is almost always in the water getting to the tub rather than the tub itself. Work through the short list below before assuming the machine is broken.
Start at the Wall
- Confirm both hot and cold taps are fully open. A half-turned valve is a common cause after a move or plumbing work.
- Run a nearby sink or hose bib. If water there is weak, the house supply is the issue, not the washer.
- Check that the hoses behind the machine are not kinked or crushed against the wall.
Clean the Inlet Screens
Turn off the taps and unplug the washer. Unscrew each hose from the back of the machine with a towel beneath. Inside each inlet is a small mesh screen. Grit and mineral flakes collect there and slow the flow. Rinse them, refit the hoses hand-tight and test again.
What You Cannot Judge by Eye
If only one of the two hoses delivers water, or the tub fills with the wrong temperature, the inlet valve is a suspect. If water arrives but the cycle still does not begin, the water level switch or control may be involved. These look alike from the outside, and we confirm by testing the valve rather than guessing.
Do Not Ignore a Drip at the Valve
A damp or crusty area where a hose meets the valve means the part is leaking and will fail sooner or later. Stop using the washer if you see steady dripping.
Inlet valve and water supply problems are part of Maytag washer repair. Tell us which hose delivers water and what the tub does, and we will bring the right part to a three-hour window.