Model library · Maytag Range

MER7775WS

Maytag MER7775WS Electric Stove Repair

Most common issues on this model

Bake element worn through at one end
Burner stuck on high or never warming
Door locked after self-cleaning
Control that shows an error and will not start

MER7775WS is listed as an earlier-production Maytag electric range, and MER7775WB sits beside it in the same family. Look at your cooktop to see which version you have, because a smooth-top and a coil top use different parts. Some versions also have a warming or storage drawer below the oven. Self-clean versions lock the door while the cycle runs.

The bake element is a frequent suspect on a range with this much service behind it, since it can wear through at one end and leave the oven cold or slow. A control that shows an error and refuses to start sends us to the sensor and the connectors before we condemn the board.

We work on earlier-production ranges every week in Houston, and we are candid when a repair would cost more than it is worth. The estimate is written, the label supplies the model and serial, and our repair carries a 30-day warranty.

Key features

Maytag electric range
Smooth-top or coil top, by version
Warming or storage drawer on some versions
Bake and broil elements, self-clean on those versions
Electronic control with an oven sensor

→Codes

Error codes this model can show

PUSH or PSHMaytag Range Prompt PUSH or PSH: Press Start Sabbath, Sab, 5Ab or 5A7Maytag Range Sabbath Mode Display: Cancel Sabbath Mode Probe or Insert ProbeMaytag Range Message "Insert Probe": Meat Probe Not Detected FC E1, FC E2 or FC E3Maytag Range Codes FC E1, FC E2 or FC E3: Wi-Fi Connection Lost FC E4 or FC E5Maytag Range Codes FC E4 and FC E5: Wi-Fi Antenna Concern FC E6 or FC E9Maytag Range Codes FC E6 and FC E9: Wi-Fi Power Module FC E7Maytag Range Code FC E7: No Link to Home Router FC E8Maytag Range Code FC E8: App Registration Error

MER7775WSMER7775WS questions

My MER7775WS bake element looks burned at one end. Is that the whole problem?

Most likely, yes. A burned-through element stops heating and the oven stays cold or slow. We confirm with a meter, replace the element, and check the terminals for damage that could ruin the new one.

The control shows an error and will not start the oven. Must the board be replaced?

Not necessarily. A failing sensor or a loose connector can cause the same message, so we test those first. A board is replaced only after the cheaper causes are ruled out.

How can I tell coil from smooth-top parts on this number?

By looking at the cooktop and the label. Elements and switches differ between the two, so we match them to the exact version before ordering.

Book a visit

Book repair for your MER7775WS

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 936-6390