Error code · Washer

Maytag Washer Code F0E3: Overload on Top-Loaders, Reset on Front-Loaders

Low risk · DIY check OK

Code: F0E3
Appliance: Washer
Brand: Maytag
Warranty: 30-day workmanship

What F0E3 means

F0E3 has two readings. On Maytag top-load HE washers, from the older Bravos era through models such as the MVW6230HW, it means overload: the load is too heavy and the washer runs its overload recovery cycle. On Maytag front-load HE washers (MHW models such as the MHW5630HW), the manufacturer states no cause and gives only a power reset. In both cases you see the code during or after a wash, and clothes may come out wetter than usual.

Common causes of F0E3

A load packed too tightly or too heavy for the drum (top-loaders)
An unbalanced load that cuts the spin speed
A control stop that only a power reset clears (front-loaders)

✓ One safe check you can try

1. On a top-loader, let the overload recovery cycle run. 2. Take out some of the load and place the rest in loose heaps evenly around the basket wall. 3. On a front-loader, disconnect power for 5 minutes, then restore it. 4. Run the cycle again with a smaller, balanced load.

! Why to stop there

A washer that shows overload with a small load needs its sensing checked
On the front-loader, no cause is stated, so a repeat means we watch the machine run
If it is an older Bravos, we tell you plainly when a repair is not worth it

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Ofb or uLMaytag Top-Load Washer Code Ofb or uL: Load Out of Balance, Hands Needed oLMaytag Top-Load Washer Code oL: Load Too Large for the Tub PFMaytag Washer Code PF: Cycle Interrupted by a Power Failure Rinse Light OnMaytag Top-Load Washer Rinse Light On: Spray Rinse Is Running SdMaytag Bravos Washer Code Sd: Suds Reduction Routine at the End of the Wash Sensing or Fill LightMaytag Top-Load Washer Sensing or Fill Light: Auto Sensing Is Measuring the Load SrMaytag Neptune Washer Code Sr: System Relay Problem Sud or SdMaytag Washer Code Sud or Sd: Too Many Suds, Extra Rinsing Under Way

F0E3F0E3 questions

What does F0E3 mean?

On a top-load Maytag it means the load is too heavy and an overload recovery cycle is running. On a front-loader the manufacturer gives no meaning and only says to reset the power.

How should I load a top-loader?

Place garments in loose heaps evenly around the basket wall, not packed tight. A large unbalanced load can lower the spin speed and leave clothes wet at the end.

What if it still happens with a small load?

Then something besides the load is involved. We test it, give you a written price before work, and our repairs carry a 30-day workmanship warranty.

Book a visit

Still unsure about F0E3?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390