Error code · Dishwasher

Maytag Dishwasher Code F2E1: Stuck Key or Console

Medium · inspection needed

Code: F2E1
Appliance: Dishwasher
Brand: Maytag
Warranty: 30-day workmanship

What F2E1 means

F2E1 on Maytag built-in dishwashers with electronic control refers to a stuck key or console error. The control is detecting a key press that is not happening, or the console is not behaving normally. At the dishwasher you may see two flashes, a pause, and one flash, buttons that do nothing, or a cycle that will not begin. This code describes the console area first, so that is where we start.

Common causes of F2E1

Key on the console reading as pressed
Moisture or film on the touch area
Console connection to the main control
Console panel itself after the wiring is checked

✓ One safe check you can try

1. Dry the console with a soft cloth. 2. Turn off the dishwasher's breaker for 30 seconds if it is hard wired, or unplug it for the same time. 3. Restore power. 4. Try a cycle. 5. If F2E1 returns, schedule service.

! Why to stop there

A key that stays registered after a reset needs a hands-on test
We check each key and the connection behind the console
Residue on the panel can imitate a bad console, so we clean and test before we replace anything

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E2Maytag Dishwasher Code F8E2: Fill Valve Electrical F8E4Maytag Dishwasher Code F8E4: Check the Supply Connections F8E5Maytag Dishwasher Code F8E5: Fill Valve Stuck Open, Shut Off the Water F9E1Maytag Dishwasher Code F9E1: Slow to Drain F9E2Maytag Dishwasher Code F9E2: Drain Motor FAE4 or F10E4Maytag Dishwasher Codes FAE4 and F10E4: Diverter Valve FAE5 or F10E5Maytag Dishwasher Codes FAE5 and F10E5: Leak at the Diverter Front status light (blue / red / white / blinking; glowing red at end of Sani Rinse)Maytag Dishwasher Front Status Light: Blue, Red, White or Blinking

F2E1F2E1 questions

Can a wet console cause F2E1?

Moisture can make a key appear pressed. Wiping and drying the area is a safe first step, but a repeat of the code means the console needs a proper test.

Which button is stuck?

The code does not name the button. We test the console key by key to find the one reporting a press, and we also check the connection behind the panel.

Is it safe to keep running the dishwasher?

If it starts and finishes cycles normally after the reset, you can use it. If the console is unresponsive, it is better to leave it until we test it.

Book a visit

Still seeing F2E1?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390