Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Maytag specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 936-6390 Book a House Call
Model library · Maytag Washer

LAT2300

Maytag LAT2300 Washer Repair

Most common issues on this model

  1. Washer that stops partway through a load
  2. Leaking at the pump or a drain hose connection
  3. Rattle or squeal during spin
  4. Water temperature that does not match the selector
  5. Lid switch that does not register when closed

The LAT2300 series covers Maytag top-load washers, and LAT2300AWW is one version of it. These are older washers, still in many homes, built around an agitator, a transmission, a drive belt and a mechanical timer.

When one of these washers leaks, we trace the water before touching a part, since a drip may come from a hose, the pump seal or the tub rather than the place where the puddle forms. For a washer that quits midcycle we test the lid switch and timer contacts, then the motor and the belt. A squeal on spin usually sends us to the belt and pulleys.

We tell you plainly if an older washer is not worth fixing, and we say what we found before you decide. The model and serial on the plate decide the parts, so we read them first. You approve a written price, and workmanship is covered for 30 days.

Key features

  • Maytag top-load washer
  • Series that includes LAT2300AWW
  • Agitator, transmission and drive belt design
  • Mechanical timer and selector switches
  • Lid switch that cuts the spin
LAT2300LAT2300 questions
My LAT2300 leaks underneath. Where do you start?

We dry the floor, run a short cycle and watch where the water first appears. The usual sources are the fill hoses, the pump seal and the drain hose, and we replace only the part that is leaking.

Does LAT2300AWW use different parts than LAT2300?

Many parts match, because they share a base number, but the ending can mark a different version. We check the plate before ordering so the belt, pump or switch fits.

Why does my washer stop in the middle of a load?

On this type the cause is often a worn timer contact, a lid switch or an overheated motor. We test each with a meter and explain which one failed before quoting.

Book a visit

Book repair for your LAT2300

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.