Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Maytag specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 936-6390 Book a House Call
Model library · Maytag Washer

LAT2500

Maytag LAT2500 Top-Load Washer Service

Book a House Call(713) 936-6390

Most common issues on this model

  1. Agitator that jerks or stops under a full load
  2. Belt that squeals when the spin starts
  3. Pump noise followed by slow draining
  4. Fill that continues past the right water level
  5. Lid switch that clicks but the washer stays idle

LAT2500 is a Maytag top-load washer series, with LAT2500AAE listed as one version. It is an older washer that many owners keep running, and it uses a belt-driven transmission and agitator controlled by a mechanical timer.

Heavy loads are where a washer like this shows wear, and in a Houston home towels and jeans are common. If the agitator jerks or stops under weight, we check the belt tension, the motor coupling and the transmission. A fill that does not shut off points to the water level switch or the inlet valve, so we inspect those with the washer unplugged and then under power.

Where parts are hard to find, we still check what is available for your exact revision and tell you before you decide. We read the model and serial from the plate first. Expect a written price and 30 days of workmanship coverage.

Key features

  • Maytag top-load washer
  • LAT2500AAE is one listed version
  • Belt-driven agitator washer with a transmission
  • Mechanical timer with selector switches
  • Lid switch that stops the spin
→Codes

Error codes this model can show

SrMaytag Neptune Washer Code Sr: System Relay Problem Sud or SdMaytag Washer Code Sud or Sd: Too Many Suds, Extra Rinsing Under Way tEMaytag Neptune Washer Code tE: Sump Thermistor Reading Outside Normal Range uLMaytag Bravos Washer Code uL: Unbalanced Load, Correction Routine Running Wash Light On or FlashingMaytag Top-Load Washer Wash Light On or Flashing: Water Level Not Changing Ofb or uLMaytag Top-Load Washer Code Ofb or uL: Load Out of Balance, Hands Needed oLMaytag Top-Load Washer Code oL: Load Too Large for the Tub PFMaytag Washer Code PF: Cycle Interrupted by a Power Failure
LAT2500LAT2500 questions
My LAT2500 agitator jerks when the load is heavy. Is that the motor?

More often it is the belt, the coupling or the transmission. We check each by hand, then run the washer to confirm. The motor is tested last, before any part is quoted.

Why does my washer keep filling past the normal level?

A water level switch that does not trip, or an inlet valve that does not close, can do it. We check both and shut the water off at the faucet if the valve is passing.

Are parts for an older LAT2500 still available?

Many common parts such as belts, pumps, switches and timers are available, though some depend on the revision. We confirm the plate numbers and tell you what we can get before you approve.

Book a visit

Book repair for your LAT2500

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 936-6390