MVWX700XL
Maytag MVWX700XL Washer Repair
Most common issues on this model
- Balance stops that repeat on normal loads
- Pump that runs while the water stays high
- Basket that will not spin after the last drain
- Lid lock that clicks without catching
MVWX700XL is a Maytag top-load washer. Its number is close to MVWX700XW, and the last letters mark a finish or revision, so the rating plate is read before we choose parts.
A washer like this commonly stands in a utility room or a garage laundry area. For service, the lid lock must latch before the basket spins, the electronic control works with a shift actuator under the tub, and the drain pump sits behind the base or the rear panel by build.
If the basket does not spin at the end of the cycle, we check the drain first, since a full tub holds the spin, then the lid lock and the shift actuator. For repeated imbalance we check level and suspension. We copy the complete plate and serial before ordering, agree the price on paper, and warrant the labor for 30 days.
Key features
- Maytag top-load washer
- Impeller or agitator wash action, by build
- Electronic control paired with a shift actuator below the tub
- Lid lock must latch before the basket spins
Error codes this model can show
My MVWX700XL does not spin at the end. What do you check?
The drain comes first, because a tub with water in it will not spin. Then the lid lock, the shift actuator and the control, in that order.
Why does the washer keep stopping on an unbalanced load?
Usually the washer is out of level or the load is lopsided. Feet and suspension are checked, then the lid switch, and parts are suggested only after that.
Where is the drain pump on this washer?
Access is from the base or the rear, depending on the build. We know which applies once we read the label, and the written price includes the labor.
Book repair for your MVWX700XL
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.