Error code · Wall Oven

Maytag Steam Wall Oven Message Please Remove and Empty Container: Drain Finished

Please Remove and Empty Container is a message on Maytag wall ovens with a steam or boiler function, such as the MEW9530FZ and MEW9627FZ. It appears at the end of the Drain cycle. It is a…

Low risk · DIY check OK

Book a House Call (713) 936-6390

Code: Please Remove and Empty Container
Appliance: Wall Oven
Brand: Maytag
Warranty: 30-day workmanship

What Please Remove and Empty Container means

Please Remove and Empty Container is a message on Maytag wall ovens with a steam or boiler function, such as the MEW9530FZ and MEW9627FZ. It appears at the end of the Drain cycle. It is a prompt, not a failure. Empty the water container, return it to its compartment before you close the oven door, then press OK. The Drain function can also be used on its own to remove any water left in the boiler, with the container emptied and replaced first.

Common causes of Please Remove and Empty Container

Drain cycle finished
Container still full or not returned to its compartment

✓ One safe check you can try

1. Open the door and take out the water container. 2. Empty it and put it back in its compartment before closing the door. 3. Press OK on the display. 4. If the message stays, check that the container is seated all the way in.

! Why to stop there

If the container is seated and the message will not clear, the sensor for it may need a look
We check the drain and the container sensing before suggesting parts
Quote in writing first, and a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

FC E4, FC E5Maytag Wall Oven Codes FC E4 and FC E5: Wi-Fi Antenna Check FC E6, FC E9Maytag Wall Oven Codes FC E6 or FC E9: Wi-Fi Power Module FC E7Maytag Wall Oven Code FC E7: No Link to Your Router FC E8Maytag Wall Oven Code FC E8: Entering the SAID Number at Setup Flashing Time, Clock, 12:00, Power Loss or Enter TimeMaytag Wall Oven Display Flashing Time, 12:00 or Power Loss: Set the Clock Locked, Lock or Loc on a Wall OvenMaytag Wall Oven Display Locked, Lock or Loc: Controls and Door Locked Probe or Insert Probe on a Wall OvenMaytag Wall Oven Message Probe or Insert Probe: Meat Probe Not Detected Registration ErrorMaytag Wall Oven Message Registration Error: Connection Needed

Please Remove and Empty ContainerPlease Remove and Empty Container questions

Is this message an error?

No. It means the Drain cycle has ended. The oven wants you to empty the container so that no water stays behind, and then you press OK to continue using the oven.

Can I run the drain on my own?

Yes. The Drain function can empty the boiler manually. Empty the water container and return it to its compartment first, as the owner's manual describes, so that no residual water is left.

What if the message keeps appearing?

Check that the container is fully seated in its compartment. If the oven keeps asking after you pressed OK, tell us, and we can test the container sensing and the drain circuit.

Book a visit

Still unsure about Please Remove and Empty Container?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390