Error code · Dishwasher

Maytag Dishwasher Clean Light Flashing: Counting the Error Pattern

Low risk · DIY check OK

Code: Clean light flashing (blink-count error code)
Appliance: Dishwasher
Brand: Maytag
Warranty: 30-day workmanship

What Clean light flashing (blink-count error code) means

When the Clean light flashes on a Maytag built-in dishwasher with an electronic control, it usually means the dishwasher is sending an error code. It uses a two-part flashing sequence: a first set of rapid flashes gives the Function (F) number, a pause of about one to two seconds follows, and a second set of rapid flashes gives the E number. Counting the two sets tells you which specific error the dishwasher is reporting.

Common causes of Clean light flashing (blink-count error code)

An error code is being sent through the Clean light
Control, sensor, water or drain circuit named by the F and E count

✓ One safe check you can try

1. Stand near the dishwasher and watch the Clean light for a full repeat. 2. Look for the distinct pause in the blinking pattern. 3. Count the first set of rapid flashes, the F number. 4. After the pause of one to two seconds, count the second set, the E number. 5. Note both numbers.

! Why to stop there

The pattern says which circuit is involved but not whether a part has failed
We use the F and E count to choose the right test
A clearly counted pattern lets us bring the right part list to the visit

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4Maytag Dishwasher Code F8E4: Check the Supply Connections F8E5Maytag Dishwasher Code F8E5: Fill Valve Stuck Open, Shut Off the Water F9E1Maytag Dishwasher Code F9E1: Slow to Drain F9E2Maytag Dishwasher Code F9E2: Drain Motor FAE4 or F10E4Maytag Dishwasher Codes FAE4 and F10E4: Diverter Valve FAE5 or F10E5Maytag Dishwasher Codes FAE5 and F10E5: Leak at the Diverter Front status light (blue / red / white / blinking; glowing red at end of Sani Rinse)Maytag Dishwasher Front Status Light: Blue, Red, White or Blinking F3E2Maytag Dishwasher Code F3E2: Thermistor or OWI Sensor

Clean light flashing (blink-count error code)Clean light flashing (blink-count error code) questions

Does a flashing Clean light always mean an error?

Usually, yes, when the lights flash in the two-part rhythm. A single steady pattern during a normal cycle is different, so watch for the pause between sets.

How long should I watch the light?

Watch at least two repeats of the sequence. A single pass can be easy to miscount, and the second pass confirms your F and E numbers.

What do I tell you when I call?

Give us the F and E counts, for example F8 and E1. That single detail lets us arrive knowing which circuit to test first, and it saves time on the visit.

Book a visit

Still unsure about Clean light flashing (blink-count error code)?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390