Error code · Wall Oven

Maytag Wall Oven Code 3D31, 3D32 or 3D41: Meat Probe Seating

Low risk · DIY check OK

Code: 3d31, 3d32, 3d41
Appliance: Wall Oven
Brand: Maytag
Warranty: 30-day workmanship

What 3d31, 3d32, 3d41 means

The codes 3d31, 3d32 and 3d41 on a Maytag built-in wall oven refer to the meat probe. The manufacturer's first instruction is to confirm the probe is pushed in securely in its receptacle, which is located in a different place on different models. The display shows the code, and the oven may not run a probe cooking cycle until the connection is solid.

Common causes of 3d31, 3d32, 3d41

A probe not fully inserted in its receptacle
The probe jack and its contacts
The probe cable itself
Control reading of the probe circuit

✓ One safe check you can try

1. Remove the probe and check that the plug and the receptacle are clean and dry. 2. Push the probe in securely until it seats. 3. Turn off the circuit breaker for one minute, then turn it back on. 4. Watch the oven for a minute to see if the code returns, then verify oven operation.

! Why to stop there

Probe, cable and jack all look alike from outside
We test the probe circuit and, if needed, the probe itself
You approve a written price first, and the work is under our 30-day warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

F9 or F9 E0Maytag Wall Oven Code F9 or F9 E0: Supply Wiring Polarity Code shown as "F" and a number, beeping (older wall ovens)Maytag Older Wall Oven Code F With a Number and Beeping: Cancel, Then Power Down FC E1, FC E2, FC E3Maytag Wall Oven Codes FC E1, FC E2 and FC E3: Cannot Reach the Router FC E4, FC E5Maytag Wall Oven Codes FC E4 and FC E5: Wi-Fi Antenna Check FC E6, FC E9Maytag Wall Oven Codes FC E6 or FC E9: Wi-Fi Power Module FC E7Maytag Wall Oven Code FC E7: No Link to Your Router FC E8Maytag Wall Oven Code FC E8: Entering the SAID Number at Setup Flashing Time, Clock, 12:00, Power Loss or Enter TimeMaytag Wall Oven Display Flashing Time, 12:00 or Power Loss: Set the Clock

3d31, 3d32, 3d413d31, 3d32, 3d41 questions

Can I cook without the meat probe?

Yes. Use a normal timed bake. The probe code only affects probe cooking. If the code appears during a timed bake, tell us.

The probe is seated and the code stays. What now?

Try a second reset. If the code returns, the probe, its jack or the wiring needs testing. We check each one rather than assume.

Do you repair older Maytag wall ovens with probe codes?

Yes. We write the price down first and tell you plainly if a repair is not worth it on an older oven.

Book a visit

Still unsure about 3d31, 3d32, 3d41?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390