Error code · Wall Oven

Maytag Wall Oven Message Door in Microwave Display: Door Switch Check

Medium · inspection needed

Code: Door in Microwave Display
Appliance: Wall Oven
Brand: Maytag
Warranty: 30-day workmanship

What Door in Microwave Display means

When the word Door shows in the microwave section of a Maytag built-in wall oven, the manufacturer says to open and close the door. The control is looking for input from the door switches. The oven may not start the microwave function until it sees the door close properly. If the message stays, the cause could be a switch or its wiring.

Common causes of Door in Microwave Display

The microwave door switches
Wiring to the door switches
Door alignment and latch engagement
Control reading of the door state

✓ One safe check you can try

1. Open the microwave door fully and close it firmly. 2. Make sure nothing, such as a dish towel or food residue, keeps the door from closing. 3. Turn the oven's circuit breaker off for one minute, then back on. 4. Wait one minute, then verify that the oven works.

! Why to stop there

A door that seems closed may not press the switches fully
We test the switch inputs and wiring and look at how the door seats
Written price first, 30-day warranty on our repair

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

F8 E3Maytag Wall Oven Code F8 E3: Oven Cooling Fan, Wiring and Control F8 E4, F8 E5Maytag Wall Oven Codes F8 E4 and F8 E5: Exhaust Fan Air Temperature Sensor F9 or F9 E0Maytag Wall Oven Code F9 or F9 E0: Supply Wiring Polarity Code shown as "F" and a number, beeping (older wall ovens)Maytag Older Wall Oven Code F With a Number and Beeping: Cancel, Then Power Down FC E1, FC E2, FC E3Maytag Wall Oven Codes FC E1, FC E2 and FC E3: Cannot Reach the Router FC E4, FC E5Maytag Wall Oven Codes FC E4 and FC E5: Wi-Fi Antenna Check FC E6, FC E9Maytag Wall Oven Codes FC E6 or FC E9: Wi-Fi Power Module FC E7Maytag Wall Oven Code FC E7: No Link to Your Router

Door in Microwave DisplayDoor in Microwave Display questions

Why does the word Door stay on the screen?

The control has not received the signal it expects from the door switches. Usually that means a switch or its wiring, but we check the door seating too.

Can I force the door shut harder?

No. Pushing hard can damage the latch. Close the door normally. If it does not register, leave it for a proper test.

Will you repair an older Maytag combination wall oven with this message?

Yes. We quote in writing and tell you plainly if the repair is not worth it for an older oven.

Book a visit

Still seeing Door in Microwave Display?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 936-6390